Notes in Day 33 Flashcards - IPv6 (Part 3)

To Subscribe, use this Key

Status	Last Update	Fields
Published	03/05/2024	Which IPv6 header field indicates the version of IP?
Published	03/05/2024	Which IPv6 header field is used for QoS?
Published	03/05/2024	Which IPv6 header field is used to identify specific traffic flows?
Published	03/05/2024	Which IPv6 header field indicates the length of the encapsulated Layer 4 segment?
Published	03/05/2024	What is the length of the IPv6 header?
Published	03/05/2024	Which IPv6 header field indicates the encapsulated Layer 4 protocol?
Published	03/05/2024	Which IPv6 header field functions like the IPv4 TTL field?
Published	03/05/2024	How is an IPv6 solicited-node multicast address calculated from a unicast address?[...]  +  Last 6 hex digits of unicast address
Published	03/05/2024	How is an IPv6 solicited-node multicast address calculated from a unicast address?ff02::1:ff  +  [...]
Published	03/05/2024	What does NDP stand for?
Published	03/05/2024	Which protocol replaces ARP in IPv6?
Published	03/05/2024	What does the NDP 'NS' message stand for?
Published	03/05/2024	What does the NDP 'NA' message stand for?
Published	03/05/2024	What does the NDP 'RS' message stand for?
Published	03/05/2024	What does the NDP 'RA' message stand for?
Published	03/05/2024	NDP [...] = ICMPv6 Type 135
Published	03/05/2024	NDP NS = ICMPv6 Type [...]
Published	03/05/2024	NDP [...] = ICMPv6 Type 136
Published	03/05/2024	NDP NA = ICMPv6 Type [...]
Published	03/05/2024	NDP [...] = ICMPv6 Type 133
Published	03/05/2024	NDP RS = ICMPv6 Type [...]
Published	03/05/2024	NDP [...] = ICMPv6 Type 134
Published	03/05/2024	NDP RA = ICMPv6 Type [...]
Published	03/05/2024	When trying to learn a MAC address, what destination IP address are NDP NS messages sent to?
Published	03/05/2024	What command is used to view the IPv6 equivalent of an ARP table?R1# [...]
Published	03/05/2024	NDP RS messages are sent to [destination IP]
Published	03/05/2024	NDP RA messages are sent to [destination IP]
Published	03/05/2024	What does SLAAC stand for?
Published	03/05/2024	Which NDP messages allow a device to learn the network prefix for SLAAC?
Published	03/05/2024	When using SLAAC, how is the interface ID generated?
Published	03/05/2024	What does DAD stand for?
Published	03/05/2024	[...] allows hosts to check if other devices on the local link are using the same IPv6 address.
Published	03/05/2024	Which NDP messages does DAD use?
Published	03/05/2024	To perform DAD, which address does a device send an NS to?
Published	03/05/2024	Are routes for IPv6 link-local addresses added to the routing table?
Published	03/05/2024	In a directly attached static route, the [...] is specified.
Published	03/05/2024	In a [...] static route, the exit interface (only) is specified.
Published	03/05/2024	In a [...] static route, the next hop (only) is specified.
Published	03/05/2024	In a recursive static route, the [...] is specified.
Published	03/05/2024	In a [...] static route, the exit interface and next hop are both specified.
Published	03/05/2024	Configure an IPv6 directly attached static route:R1(config)# [...]
Published	03/05/2024	Configure an IPv6 recursive static route:R1(config)# [...]
Published	03/05/2024	Configure an IPv6 fully specified static route:R1(config)# [...]
Published	03/05/2024	In IPv6, you can't use [...] static routes if the interface is an Ethernet interface.
Published	03/05/2024	To use an IPv6 link-local address as a next hop, you must configure a [...] static route.
Status	Last Update	Fields