Notes in Day 25 Flashcards (1) - RIP & EIGRP

To Subscribe, use this Key

Status	Last Update	Fields
Published	03/05/2024	The maximum hop count for a RIP route is [...]
Published	03/05/2024	Which versions of RIP are used for IPv4?
Published	03/05/2024	Which version of RIP is used for IPv6?
Published	03/05/2024	RIP uses two message types:-[...]-[...]
Published	03/05/2024	RIPv[...] only advertises classful addresses.
Published	03/05/2024	RIPv[...] doesn't support VLSM and CIDR.
Published	03/05/2024	RIPv[...] supports VLSM and CIDR.
Published	03/05/2024	RIPv1 messages are sent using [...]cast.
Published	03/05/2024	RIPv2 messages are sent using [...]cast.
Published	03/05/2024	RIPv2 messages are multicast to [IPv4 address].
Published	03/05/2024	Enter RIP configuration mode:R1(config)# [...]
Published	03/05/2024	Enable RIPv2:R1(config-router)# [...]
Published	03/05/2024	Disable RIP auto summarizationR1(config-router)# [...]
Published	03/05/2024	Enable RIP on all interfaces in the specified range:R1(config-router)# [...]
Published	03/05/2024	Configure the router to stop sending RIP advertisements out of a RIP-enabled interface:R1(config-router)# [...]
Published	03/05/2024	Configure a RIP-enabled router to advertise its default route to its RIP neighbors:R1(config-router)# [...]
Published	03/05/2024	EIGRP messages are multicast to [IPv4 address]
Published	03/05/2024	RIP [can/can't] perform unequal-cost load-balancing.
Published	03/05/2024	EIGRP [can/can't] perform unequal-cost load-balancing.
Published	03/05/2024	OSPF [can/can't] perform unequal-cost load-balancing.
Published	03/05/2024	Modify RIP's AD on the local router:R1(config-router)# [...]
Published	03/05/2024	Modify the number of paths RIP will perform ECMP load-balancing over:R1(config-router)# [...]
Published	03/05/2024	Enter EIGRP configuration mode:R1(config)# [...]
Published	03/05/2024	Disable EIGRP auto summarization:R1(config-router)# [...]
Published	03/05/2024	Does the EIGRP AS number have to match between EIGRP neighbors?
Published	03/05/2024	Prevent the router from sending EIGRP messages out of an EIGRP-enabled interface:R1(config-router)# [...]
Published	03/05/2024	Enable EIGRP on interfaces in the specified range:R1(config-router)# [...]
Published	03/05/2024	EIGRP Router ID selection priority:1. [...]2. Highest IP address on a loopback interface3. Highest IP address on a physical interface
Published	03/05/2024	EIGRP Router ID selection priority:1. Manual configuration2. [...]3. Highest IP address on a physical interface
Published	03/05/2024	EIGRP Router ID selection priority:1. Manual configuration2. Highest IP address on a loopback interface3. [...]
Published	03/05/2024	Configure the EIGRP router ID:R1(config-router)# [...]
Status	Last Update	Fields