Notes in Day 51 Flashcards - Dynamic ARP Inspection

To Subscribe, use this Key

Status	Last Update	Fields
Published	03/05/2024	Enable DAI for a VLAN:SW1(config)# [...]
Published	03/05/2024	Enable err-disable recovery for DAI rate limiting:SW1(config)# [...]
Published	03/05/2024	Enable additional DAI validation checks:SW1(config)# [...]
Published	03/05/2024	Configure a DAI trusted interface:SW1(config-if)# [...]
Published	03/05/2024	Configure DAI rate limiting:SW1(config-if)# [...]
Published	03/05/2024	Create an ARP ACL:SW1(config)# [...]
Published	03/05/2024	Configure an ARP ACL entry mapping an IP address to a MAC address (permit)SW1(config-arp-nacl)# [...]
Published	03/05/2024	Apply an ARP ACL to DAI:SW1(config)# [...]
Published	03/05/2024	Show a summary of DAI configuration and statistics:SW1# [...]
Published	03/05/2024	Show a summary of DAI interfaces:SW1# [...]
Published	03/05/2024	DAI: All ports are [trusted/untrusted] by default.
Published	03/05/2024	DAI checks ARP messages' [...] and [...] fields against the DHCP snooping binding table and ARP ACLs.
Published	03/05/2024	DAI checks ARP messages' sender MAC and sender IP fields against the [...] and [...].
Published	03/05/2024	DAI inspects ARP messages received on [...] ports.
Published	03/05/2024	Does DAI inspect messages received on trusted ports?
Published	03/05/2024	DAI rate limiting is enabled on [...] ports by default.
Published	03/05/2024	DAI rate limiting is enabled on untrusted ports with a rate of [...] by default.
Status	Last Update	Fields